Channel Recall
Channel Recall
can be used to migrate to the last called Zone-channel by pressing the
Channel Recall
key.
Even if a user is away from the transceiver, the user can notice later that the transceiver has received a call during the scan.
Note
0
If the
Channel Recall
key is pressed while no signal is received after scan starts, the transceiver migrates to the channel
from which the transceiver started scanning.
0
If
Channel Recall
is enabled, the transceiver does not resume the scan even if the time configured in
Dropout Delay
Time
or
Dwell Time
elapses.
0
Channel Recall
is disabled if the channel is changed while
Channel Recall
is enabled. The transceiver resumes scanning
after the Key Delay Time elapses (1 sec).
0
The transceiver does not execute Lookback while
Channel Recall
is enabled.
0
If
Channel Recall
is enabled and the scan is paused, a Scan Stop Tone (2 beeps) sounds from the transceiver at 30-
sec intervals.
0
The channel to which the transceiver migrated using
Channel Recall
is not configured as the Selected Channel.
0
Even if
Channel Recall
is enabled, the transmission using GPS Auto is executed by
Revert Channel
.
Configuration using KPG-D1/ D1N
Assigning functions to the
PF
keys on the transceiver (
Transceiver Settings > Key Assignment)
Priority-channel Stop Tone
Priority-channel Stop Tone
is the function that emits a Priority-channel Tone (1 beep) from the transceiver when the scan
is paused and the speaker is unmuted upon receipt of a signal on a Priority Channel during the scan.
Configuration using KPG-D1/ D1N
Configuring
Priority-channel Stop Tone
to be enabled or disabled (
Transceiver Settings > Scan Information >
General)
Auto Scan
Auto Scan
is the function to start the scan automatically by selecting the channel with
Auto Scan
enabled.
Whether to enable or disable
Auto Scan
can be configured for each channel. The scan on a channel where
Auto Scan
is
enabled cannot be stopped. The scan starts unconditionally if the transceiver migrates to a channel with
Auto Scan
enabled.
Note
0
If “Personality” is configured in
Zone-channel Format
for KPG-D1/ D1N, whether to enable or disable
Auto Scan
can
be configured for each Personality.
0
When the transceiver migrates to a channel where
Auto Scan
is enabled, the scan pauses if the conditions for starting
the scan are not satisfied.
0
If the transceiver migrates to a channel where
Auto Scan
is enabled after the scan is started by pressing the
Scan
key,
the scan cannot be terminated even if the
Scan key
is pressed.
0
In a zone where “None” is configured in
Scan Type
, the scan does not start even if the transceiver migrates to a channel
with
Auto Scan
enabled.
6 SCAN
6.8 Scan Function
P25 FUNC (K)/Ver 2.20
222
