12
KIV-700/BT900
[2]
(Remote
controller)
• POWER ON time display
· Image of display
P o n T i m _ 0 H x x _
x x x x x
(In the “xx”, the
fi
gure between 00 and 50 (00~50) shall be displayed. When it is less than 1 hour, it shall be dis-
played rounded up/down to 10 minutes.)
When the unit is normally turned on even only 1 time, the value “0H10” is memorized.
(In the “xxxxxx”, the
fi
gure between 00001 and 10922 (00001~10922) shall be displayed. The
fi
gure is shown in h
[hour])
[AUD]
When this key is pressed brie
fl
y: Invalid (It does not cause any operation.)
When this key is pressed and held: It is to clear the service information being displayed (Press and hold this key for
2 seconds while the service information is being displayed)
[MENU]
When this key is pressed brie
fl
y: Version & service information display mode is turned OFF (Recover)
Initialization of settings related to AUDIO setup
y
When [
] key is pressed brie
fl
y in STANDBY source, AUDIO setting values are reset to their default values in the test mode.
SoC forced update method
y
In the Test mode, F/W in the SoC
μ
-com is automatically updated.
As a condition, this automatic update is carried out if the
fi
le, “player_nand_fup.rom” exists under the root of the USB de-
vice.
Step 1: Insert USB.
Step 2: The display should change to “Updating”.
Step 3: The display, “Complete”, is displayed to show the completion of the update.
Note:
Do not remove the USB while “Updating” is being displayed.
Others
y
Do not display “CODE_NG”, “CODE_OFF” or “CODE_ON” when power is on (POWER ON).
y
In turning on this unit in the test mode, change LINE MUTE inhibit period of time from 10sec to 1sec.
y
In the Test mode, even if the DC offset error is detected, the detection information shall not be written in E2PROM or Data
Flash ROM.
y
In the Test mode, even if the prescribed period of time elapses, the backup memory items are not written in E2PROM or
Data Flash ROM.
y
Do not run DEMO mode in the following mode: Test mode, Backup/Installer memory & CD mechanism information & service
information & DC offset error detection information & BT memory information clear mode, or DC offset error detection infor-
mation clear mode.
Also, in the above mode, do not display DEMO ON/OFF switching items in the Menu list.
■
TUNER source test mode
y
Only in the test mode, display the items for “1”~“6” under the Menu list layers that can be entered by pressing [MENU] key
so that these items are selectable. (Test 1 through Test 6 shall be displayed.
∗
In FM of RDS (RBDS) model, the “Test 6” be-
comes “K3I
∗∗∗
”.)
1. Press [MENU] key brie
fl
y to display the Menu list.
2. Use [Rotary] to select (focus at) one of “Test 1” through “Test 6”.
3.
Press [AUD] key brie
fl
y to enter the above selection. Also, it shall be possible with the keys, [1] through [6] on the remote
controller to make the same selection as above.
y
Switch frequency to 97.9MHz by pressing [3] key brie
fl
y in FM band.
TEST MODE
