key
flip top lid
lid release button
water level windows
on/off switch with neon
360° powerbase
cord wrap
scale filter
to use your jug kettle
1 Fill it through the spout or lid. To
open the lid, press the lid release
button. The water level must be
between ‘MAX’ and 200mls (1
cup).
●
Be economical: do not boil more
water than you need.
●
To improve the quality of your
drinks always use fresh water.
●
Empty the kettle after each use.
2 Check the lid is closed.
3 Plug in and switch on. The neon
will come on.
4 Your kettle will boil and switch off
automatically. To re-boil, wait a
few seconds - the on/off switch
needs time to reset.
●
If you experience problems
with your kettle switching
on and off during use or
switching off before boiling,
check that the flat element
is free from scale - see
“descaling”. If descaling
does not solve the problem
contact Kenwood Customer
Care.
●
Your kettle is fitted with a scale
filter to hold back limescale
particles.
●
If you find drops of water under
your kettle, don’t worry - it is just
condensation.
boil-dry protection
●
If you switch on with too little
water, your kettle will cut out
automatically. Switch off and let it
cool down before re-filling. When it
has cooled down, the switch will
reset itself.
care and cleaning
●
Before cleaning, unplug your kettle
and let it cool down.
the outside and powerbase
●
Wipe with a damp cloth, then dry.
Do not use abrasives - they will
scratch the plastic surfaces.
the inside
●
Wipe with bicarbonate of soda on
a damp cloth. Rinse thoroughly.
●
Even though your kettle comes
with a scale filter, you still need to
clean the inside (and the filter)
regularly.
the scale filter
1 Press the lid release button
.
2 Gently lift out the scale filter
.
3
either
rinse under the tap or use
a soft brush.
or
when descaling your kettle,
drop the filter in too. Rinse
thoroughly.
4 To re-fit the scale filter, slide it in
until it rests on the notch under the
spout
.
safety
●
Avoid contact with steam coming
out of the spout area when
pouring and out of the lid when
refilling.
●
Keep small children away from the
kettle and never let the cord hang
down over the worktop edge - a
child could grab it and pull the
kettle down.
●
If you do not need so much cord,
shorten it by wrapping any excess
cord around the bracket on the
underside of the powerbase
.
●
Always unplug your kettle
when not in use.
●
Never overfill - boiling water may
splash out.
●
Never put the kettle, powerbase,
cord or plug in liquid.
●
Do not use if there is
any
damage
to the kettle, powerbase, cord or
plug. Get it checked or repaired:
see ‘service’.
●
This kettle is not intended for use
by young children or infirm persons
without supervision.
●
Young children should be
supervised to ensure they do not
play with the appliance.
●
Caution:
Do not operate the
kettle on an inclined surface.
●
Only use the powerbase supplied
and keep it clean and dry.
●
Make sure the lid is secure before
switching the kettle on.
●
Warning:
Do not open the lid
while the water is boiling.
●
Take care when opening the lid -
droplets of hot water may be
ejected.
●
Make sure the kettle is switched
off before lifting or pouring.
●
Remove the kettle from the base
before filling or pouring.
●
Never put the kettle near or on
cooker hot plates or gas burners.
●
This kettle is for boiling water only.
●
This kettle is for domestic use only.
●
Failure to observe these cautions
may result in damage to the kettle.
before plugging in
●
Make sure your electricity supply is
the same as the one shown on the
underside of your kettle.
Important - UK only
●
The wires in the cord are coloured
as follows:
Green and Yellow = Earth, Blue =
Neutral, Brown = Live.
●
The appliance must be protected
by a 13A approved (BS1362) fuse.
●
WARNING: THIS APPLIANCE
MUST BE EARTHED.
Note:
●
For non-rewireable plugs the fuse
cover MUST be refitted when
replacing the fuse. If the fuse cover
is lost then the plug must not be
used until a replacement can be
obtained. The correct fuse cover is
identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).
●
If a non-rewireable plug is cut off it
must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable pug is inadvertently
inserted into a 13A socket outlet.
●
This kettle complies with European
Economic Community Directive
89/336/EEC.
before using for the first
time
●
Remove all packaging and any
labels.
●
Fill to ‘MAX’, boil, then pour the
water away. Repeat 2 to 3 times.
2
4
6
8
2
4
6
8
2
4
6
8
