65
Knowledge section
Preparation section
Application section
Basic section
Convenient recording of CD player output
Program the desired sequence of CD tracks.
Check the current play mode of the CD player.
1
3
1
Perform steps 1~3 of the procedure in ”Recording
on TAPE”.
‚
2
Select the “CD” input.
¢
3
Load the recording source disc in the CD player.
¢
Make the preparations for recording.
Be sure to put the cassette deck in stop mode.
Desired CD tracks can be programmed in the desired sequence and recorded onto a tape.
Program recording
(PGM mode + O.T.E.)
2
÷
Recording begins from the first track in the program and
completes when the entire program has been recorded.
÷
When either the playback or recording operation stops, the
other operation also stops.
÷
When you are operating the main unit, select
“O.T.E. Mode”
in the menu mode then select
“CD
=
=
=
=
=
TAPE“
and press the
SET
key to start recording.
÷
When recording completes, the tape stops after leaving a no-
sound blank of about 4 seconds.
Start recording.
4
Perform steps
2
and
3
of the procedure in ”Lis-
tening in the desired sequence (Program play-
back)”.
u
CD
TAPE
=
To interrupt a recording
STOP
7
CD
=
TAPE
This system can record signals on Normal (TYPE ) and
High (TYPE ) position tapes. Remember that the Metal
(TYPE
) tapes cannot be used with this system.
Do not use a cassette tape with more than 90-minute recording time, for the tape used with such a cassette is very
thin and tends to cause troubles such as entanglement around the pinch roller or cutting of tape.
Press the
7
(stop) key on the main unit or
7
STOP
key on the remote. (This stops both recording and
playback.)
If it is in play mode, stop it.