Kenwood DRV-N520, Инструкция по эксплуатации

Страница: 10 / 48

10
How to Wire
To prevent a short circuit, remove the key from the ignition and disconnect the
¤
terminal of the battery.
1.
Connect the power cord (accessory
1
) to the Dashboard camera.
Power cord
1
Camera lens
2.
Mount the cable holder (accessory
3
) in position by inserting it into
the slot in the Dashboard camera and also inserting its claw into the
connector of the Dashboard camera.
Slot
Cable holder
3
Cable holder
3
Claw
3.
Make connections
• Settings are required to connect the Dashboard camera. Refer to the instructions
supplied the receiver.
–
For the model having a video input connector with a DASH CAM tag, connect the
video output to the Front view camera/Dashboard camera input connector (yellow).
–
For the model that does not have a video input connector with a DASH CAM tag,
connect the optionally available CA-C3AV to the AV-IN input port of the receiver, and
then connect the video output to the video input connector (yellow) of the CA-C3AV.
Slot
CAUTION
DRV-N520W_EN301.indd 10 2017/03/08 14:05