Kenwood DRV-830, Инструкция по эксплуатации

Страница: 3 / 25

Dashboard camera Function Guide
This dashboard camera records videos and still pictures and stores them
on the microSD card (hereafter referred to as “SD card”).
Be sure to insert the SD card into SD card slot 1 before using the camera.
SD card slot 2 is extend storage capacity for normal recording data.
About the setup function
The setup menu is displayed the first time the camera ' s power is turned on.
Follow the instructions on the menu screen to configure the settings and complete the basic
setup related to installation. The settings can also be configured in the same way using the
setup function from the MENU settings.
( ➜ P. 31)
About the recording functions
The camera can record images while you are driving (when the camera's power is on) (normal
recording).
Furthermore, the camera can record images before and after major impacts to the vehicle or
directly after impacts while the vehicle is running or parked (event recording/parked recording).
Continuous recording
Approximately 10 seconds before impact
Arrival
Arrival
Recording is performed all the time, from when the power is turned on until it is turned off.
When the camera detects an impact, the mode switches from
continuous
recording to event recording,
and the video file of the time before and after the impact was detected is saved.
When the vehicle is parked, in a parking lot or elsewhere, and the engine key is turned off, the parked
recording function is set to standby, and recording starts if an impact to the vehicle is detected.
Go
Go
Continuous recording
Event recording
Parked recording
Parked recording function Standby Parked recording starts
Impact
Event recording (for approximately 25 seconds)
Continuous recording Continuous recording
Approximately 15 seconds after impact
The time for recording after the
impact is detected can be changed.
* When there was an impact between the start time (when you left the vehicle) and the stop
time (when you got into the vehicle), recording is not possible.
The CA-DR100 power cable for Dashcam (optional
accessory) is required to enable the parked recording function.
Impact
P. 19
P. 21
P. 21
Continuous recording
Approximately 10 seconds before impact
Arrival
Arrival
Recording is performed all the time, from when the power is turned on until it is turned off.
When the camera detects an impact, the mode switches from
continuous
recording to event recording,
and the video file of the time before and after the impact was detected is saved.
When the vehicle is parked, in a parking lot or elsewhere, and the engine key is turned off, the parked
recording function is set to standby, and recording starts if an impact to the vehicle is detected.
Go
Go
Continuous recording
Event recording
Parked recording
Parked recording function Standby Parked recording starts
Impact
Event recording (for approximately 25 seconds)
Continuous recording Continuous recording
Approximately 15 seconds after impact
The time for recording after the
impact is detected can be changed.
* When there was an impact between the start time (when you left the vehicle) and the stop
time (when you got into the vehicle), recording is not possible.
The CA-DR100 power cable for Dashcam (optional
accessory) is required to enable the parked recording function.
Impact
„ Other recording functions
Still image recording:
When the [
]
button is pressed during recording, the image being
recorded is stored as a still image.
Automatic still image capture:
When the [
]
button is pressed and held for over 1 second
during recording, the set number of still images is captured automatically at a specific interval.
(over 1 second)
P. 22
P. 22
P. 23
5 4