Kenwood DNX5350BT, Инструкция по эксплуатации

Страница: 101 / 129

100 100
Return to the Top page
Controlling Audio
Gain level (light green boxed area)
Adjust the gain level by touching the each
frequency bar.
Touching [
2
], [
3
], [
5
] and [
∞
] can also
adjust the level. Use [
2
] and [
3
] to select a
frequency, and [
5
] and [
∞
] to set the level.
EQ INIT
Returns to the previous level which the gain
level is adjusted.
Flat
Tone curve becomes flat.
Bass EXT (Bass Extend Settings)
When turned on, the frequency lower than
62.5 Hz is set to the same gain level as 62.5 Hz.
Loudness
Sets the amounts of boost of low and high
tones.
DNX5350BT, DNX5350DAB: “OFF”, “Low”, “High”
DNX535VBT: “OFF”, “ON”
SW Level
Adjusts the subwoofer volume. This setting is
not available when subwoofer is set to “None”.
See
Speaker setup (P.95)
.
Zone Control
You can select different sources for both
front and rear positions in the vehicle.
1
Touch [Zone Control].
Zone Control screen appears.
2
Touch [Dual Zone].
3
Set each source as follows.
[ 3 ] (Front Source, Rear Source)
Select the audio source for each.
[
∞
], [
5
] (Rear VOL.)
Adjusts the rear channel volume.
[Single Zone]
Touch to turn off the dual zone function.