Kenwood DNX5180S, Инструкция по эксплуатации

Страница: 63 / 100

Setup
63
English
6
Adjust the date, then adjust the time.
7
Touch
[
Set
]
.
Ñ
Learning function of steering
remote
This function is available only when your
vehicle is equipped with the electrical steering
remote controller.
If your steering remote controller is not
compliant, learning may not be completed
and error message may appear.
1
Touch
[
Steering Remote Controller
]
in
the User Interface screen.
h h Steering Remote Controller Setting
screen appears.
2
Press and hold the steering remote
controller button
NOTE
• You can have the unit learned all buttons
at a time. In that case, press the all buttons
one at a time and after pressing all of them,
touch
[
Learning completed
]
in Steering
Remote Controller Setting screen. However,
new functions cannot be learned after this
operation.
3
Touch the function you want to set.
4
Repeat steps 2 and 3 as necessary.
5
Touch
[
Learning completed
]
.
NOTE
• When changing the function already learned,
press and hold the button you want to change
in step 2 and then touch to select the changed
function from the function list.
• Confirm the contents of the settable function on
the function list. You cannot edit the function list.
• To initialize the contents, touch [
Learning
initialisation
]
of
[
Steering Remote
Controller
]
in User Interface screen. After you
touch
[
Initialise
]
, a confirmation message
appears. Follow the message and complete the
operation.
Special Setup
You can setup special parameters.
1
Press the
[
MENU
]
button.
h h Popup menu appears.
2
Touch
[
SETUP
]
.
h h SETUP screen appears.
3
Touch
[
Special
]
.
h h
Special screen appears.
4
Set each parameter as follows.
■
[
DEMO
]
Select the demonstration mode. Default is
“ON”.
■ [
Software Information
]
Confirm the software version of this unit.
(P.64)
■ [
Open Source Licenses
]
Display the open source licenses.
!B5A-2484-00_18DNX_M_En.indb 63 2018/02/19 20:35