Kenwood DNX4310DAB, Инструкция по эксплуатации

Страница: 4 / 55

66 7
Return to the Top page
Basic Operations
Return to the Top page
Basic Operations
F
unctions Of The Buttons On The Front Panel
DNX531VBT/DNX531VBTM
1
16 15 14
7
9
8
2
3
4
5
6
10
11
12
13
NOTE
• The panels shown in this guide are examples used to provide clear explanations of the operations. For this reason,
they may be different from the actual panels.
• In this manual, each model name is abbreviated as follows.
DNX531VBT and DNX531VBTM :
If above icon is showed, read the article applicable to the unit you use.
Number Name Motion
1
0
(Eject) • Ejects the disc.
• Pressing for 1 second ejects the disc forcibly.
2
MENU • Displays the Top Menu screen (P.16)
• Pressing for 1 second turns the power off.
• When the power off, turns the power on.
3
NAV • Displays the navigation screen.
• Pressing for 1 second switches AV out sources.
4
TEL • Displays the Hands Free screen (P.58) .
• Pressing for 1 second turns off the display.
5
SCRN • Displays the Screen Control screen.
• Pressing for 1 second displays rear view camera display.
B
asic Operations
Number Name Motion
6
Volume Knob • Turning adjusts volume up or down.
• Pressing switches attenuation of the volume on/off.
7
Reset If the unit or the connected unit fails to operate properly, the unit returns
to factory settings when this button is pressed
(P.95) .
8
microSD card
slot A slot to insert a microSD card. The card is used for upgrading the map. For
how to upgrade the map, refer to the instruction manual of the navigation
system.
9
Remote
Sensor • Receives the remote control signal.
• You can enable or disable this feature by Remote Sensor
(P.71) .
• If [Remote Sensor] is set to off, the remote control of TV reception is
rejected.
10
AUDIO Displays the Tone Control screen
(P.85)
.*
11
USB Switches to the USB or iPod sources
(P.72)
.
12
DISC Switches to the disc media sources.
13
TUNER Switches to the Tuner sources.
14
Release key Detaches the part of front panel.
15
Disc insert
slot A slot to insert a disc media.
16
SI indicator If the SI function is turned on, this indicator flashes when the panel is
detached
(P.74) .
* The display may not switch to the Graphic Equalizer screen in some conditions.
How To Insert A microSD Card
1) Open the
8
microSD card slot cover as the diagram
in the right.
2) Hold the microSD card with the pins facing left and
the notched section down, and insert it into the slot
until it clicks.
●
To eject the card:
Push the card until it clicks and then remove your finger from
the card.
The card pops up so that you can pull it out with your fingers.
Pins side