How to Pair a Phone (General Information for other Makes/Models)
There are two methods used to register your phone, you can generally use either method, but some
phones will only work using one or the other methods below (So if the first method doesn’t work and you
have tried to pair several times using this method, then try the second method).
After pairing the initial download of your phonebook may take up to 5 minutes, please be patient.
6
Pairing From the Phone:
Method 1
– (Exact method may vary depending on the phone make/model please consult the phone’s
instruction manual):
1. Ensure that the Bluetooth is switched on, on the phone
2. In the phone’s menu system, select
“BLUETOOTH”
or something similar
3. Then
select
“SEARCH FOR DEVICES”
or something similar
4. The phone should find
“DNX4210BT”
or
“DNX4210DAB”
5. Select this and enter the default pin code
“0000”
6. Wait while your phone pairs with the Kenwood Navigation System
7. Confirm any additional commands shown on your phone’s display to allow Bluetooth connection
The phone will search for available devices.
8. Select
“ DNX4210BT”
or
“DNX4210DAB”
from the list
9. Enter the default pin code
“0000”
when prompted
The phone will connect after 30 seconds to 1 minute
Pairing From the Kenwood Navigation System:
Method 2
– (Exact method may vary depending on the phone make/model please consult the phones
instruction manual):
1. Ensure that the Bluetooth is switched on, on the phone
On the Kenwood Navigation System:
METHOD 1
METHOD 2
3. Select
[BT SET-UP]
2. Select
[TEL]
either on screen icon in the
“TOP MENU”
screen or hard key
The Kenwood Navigation System will search for available
devices.
5. Select the your phone from the list
6. Enter the default pin code
“0000”
when prompted
The phone will connect after 30 seconds to 1 minute
4. Select
[REGISTER NEW DEVICE]
