Kenwood DNN770HD, Быстрый старт

Страница: 29 / 172

EN
29
DNN990HD/ DNN770HD
GPS antenna
GPS antenna is installed inside of
the car. It should be installed as
horizontally as possible to allow easy
reception of the GPS satellite signals.
To mount the GPS antenna inside
your vehicle:
1) Clean your dashboard or other
surface.
2) Remove the separator of the
metal plate (accessory
0
).
3) Press the metal plate (accessory
0
) down firmly on your
dashboard or other mounting
surface. You can bend the metal
plate (accessory
0
) to conform to
a curved surface, if necessary.
4) Remove the separator of the GPS
antenna (accessory
9
), and stick
the antenna to the metal plate
(accessory
0
).
0
9
•
Depending on the type of car, reception
of the GPS satellite signals might not be
possible with an inside installation.
•
The GPS antenna should be installed at
a position that is spaced at least 12 inch
(30 cm) from cellular phone or other
transmitting antennas. Signals from the
GPS satellite may be interfered with by
these types of communication.
•
Painting the GPS antenna with (metallic)
paint may cause a drop in performance.
Microphone unit and Push-To-
Talk Switch
1) Check the installation position
of the microphone (accessory
-
) and the Push-To-Talk switch
(accessory
=
: DNN990HD only).
2) Clean the installation surface.
3) Install the microphone.
4) Wire the microphone cable up to
the unit with it secured at several
positions using tape or other
desired method.
-
=
Fix a cable with a commercial item of tape.
Remove the separator of the
microphone, and stick the
microphone to the place shown
above.
Adjust the direction of the
microphone to the driver.
Continued
B59-2163-00_00_QSG_K.indb 29 13/01/18 13:51