Kenwood DMX100BT, Инструкция по эксплуатации

Страница: 22 / 52

22
About this Unit
More information
Ñ
Playable Audio files
Audio
format
Bit rate Sampling frequency
MP3 (.mp3) 16 – 320kbps,
VBR 16 – 48 kHz
WMA (.wma 16 – 320kbps 16 – 48 kHz
AAC-LC (.m4a) 16 – 320kbps 16 – 48 kHz
• This unit can show ID3 Tag Version 1.0/1.1/2.2/2.3/2.4
(for MP3).
• The maximum number of characters:
– Tag : 30 characters
✎
NOTE
• WMA and AAC of which is covered with DRM cannot
be played.
• Although the audio files are complied with the
standards listed above, the play may be impossible
depending on the types or conditions of media or
device.
Ñ
Acceptable Video files
Video
format
Video codec Audio codec
MPEG-1
(.mpg, .mpeg) MPEG-1 MPEG Audio Layer 2
MPEG-2
(.mpg, .mpeg) MPEG-2 MPEG Audio Layer 2
MPEG-4
(.mp4, .avi) MPEG-4 MP3, AAC-LC (2ch)
Ñ
Acceptable Picture files
• JPEG (.jpg)
32 x 32 to 8 192 x 7 680 resolution
– It may take time to display the file.
– Progressive JPEG files or lossless JPEG files cannot
be played.
• BMP (.bmp)
32 x 32 to 8 192 x 7 680 resolution
– It may take time to display the file.
Troubleshooting
What appears to be trouble is not always serious.
Check the following points before calling a service
center.
• For operations with the external components, refer
also to the instructions supplied with the adapters
used for the connections (as well as the instructions
supplied with the external components).
Ñ
General
No sound comes out of the speakers.
• Adjust the volume to the optimum level.
• Check the cords and connections.
The unit does not work at all.
• Reset the unit.
(P.2)
The remote controller does not work.
• Replace the battery.
Ñ
USB
“Reading” does not disappear from the screen.
• Turn the power off and on again.
While playing a track, sound is sometimes
interrupted.
• The tracks are not properly copied into the USB device.
Copy the tracks again, and try again.
Ñ
iPod/iPhone
No sound comes out of the speakers.
• Disconnect the iPod/iPhone, then connect it again.
• Select another source, then reselect “iPod”.
The iPod/iPhone does not turn on or does not
work.
• Check the connecting cable and its connection.
• Update the firmware version.
• Charge the battery.
• Reset the iPod/iPhone.
Sound is distorted.
• Deactivate the equalizer either on this unit or the
iPod/iPhone.
A lot of noise is generated.
• Turn off (uncheck) “VoiceOver” on the iPod/iPhone.
For details, visit <http://www.apple.com>.
Ñ
Radio
AME automatic presetting does not work.
• Store stations manually.
(P.10)
Static noise while listening to the radio.
• Connect the antenna firmly.
About this Unit