Kentec Electronics Taktis K772, Руководство по установке

Страница: 23 / 28

8-Way Conventional Board 6
Man-1170EN Rev.01
Additional Boards Installation Manual
18
Section 6
8-Way Conventional Board
The 8-Way Relay Board may occupy one or more slots of the panel main back board or expansion board. It provides
eight detection circuits which are compatible with a range of detection devices.
Figure 6-1
8-Way Conventional Board
A
A
D
B
C
Key Description
A
Edge connector for termination at slots on Main Back
Board slots (E&F) or Expansion Board slots (G-K).
B
Six-position DIP switch SW1 for setting the RS485 bus
address of this circuit board.
C LED provide status information – see below.
D Proprietary interface for manufacturing use only
LED Description
1
Heartbeat flashes red to identify functional status of the
Board.
2 Rx Comms lights red to identify receiving data.
3 Tx Comms lights green to identify transmitting data.
4 Fault lights red to identify an error condition.
5 Fire lights red to identify an alarm condition.
6 Output lights red to identify an output is activated.
Terminal
Designation
Uses
Terminal
Designation
Uses
1 Zone 1 +ve 9 Zone 5 +ve
2 Zone 1 -ve 10 Zone 5 -ve
3 Zone 2 +ve 11 Zone 6 +ve
4 Zone 2 -ve 12 Zone 6 -ve
5 Zone 3 +ve 13 Zone 7 +ve
6 Zone 3 -ve 14 Zone 7 -ve
7 Zone 4 +ve 15 Zone 8 +ve
8 Zone 4 -ve 16 Zone 8 -ve