Installation 2
Man-1170EN Rev.01
Additional Boards Installation Manual
6
Section 2
Installation
This section provides instructions for installing and addressing the additional boards. For general installation guid-
ance refer to the main panel Installation Instructions.
General Installation Checklist
To complete the installation:
1.
Retrieve the panel configuration file.
2.
Remove the additional card(s) packaging and check the contents.
3.
Power down the panel and disconnect the batteries.
4.
Set the Additional Board binary address.
5.
Fit the Additional Board in the appropriate Main Back Board or Extension Board slot.
6.
Attach sticker label to the appropriate field terminals board space (to board above).
7.
Make the necessary terminal connections.
8.
Connect the batteries and
power up the panel.
9.
Configure the panel to accept the new board(s) and their required functions.
10. Test the system for correct operation.
Before You Begin
Before you begin the installation, take a few minutes to review the installation information, gather the required items,
and complete the tasks listed below to make the installation as quick and easy as possible.
11. Create a plan and checklist before beginning the installation process. Planning can reduce the number
of problems that can occur during installation.
12. Verify that you received the following items with the additional board/s
The installation must be performed by qualified personnel familiar with electronic components. Electronics within
the Taktis panel (and associated boards) are vulnerable to damage from electrostatic discharge. Ground straps
should be worn by installing before handling such components to prevent electrostatic damage.
Item
Quantity
Description
Additional Board Kit
1
The additional board, the installation guide and terminal sticker label
Ground strap
1
It is advised a ground strap is used when handling all panel circuit
boards.
A ground strap is not provided with Additional Board kits.
