Evo Heat Pump Manual Version 5
Page 29 of 84
4.7 Electrical Installation
The Kensa Evo heat pump range is available in single phase power supply versions.
Any electrical work required to install or maintain this appliance should be carried out by a suitably qual-
ified electrician in accordance with current IEE regulations
To access the wiring terminals :
-
i.
If not already removed, remove the heat pump front cover by unscrewing the 1 x 5mm posidrive
screw on the top of the heat pump. See section 4.6
ii.
Remove the top panel and the rear top panel. (See below).
iii.
remove the electronics cover plate by unscrewing the two M5 pozi
-
drive head screws on the front
cover plate.
Fig 22 Plan view with the
top panels removed
Two x M5 pozidrive
screws
H
eat P
u
mp
se
ttin
gs
s
h
ee
t
W
arr
an
ty
Fau
lt
Fi
n
d
in
g
Co
n
tr
o
lle
r
Me
ch
an
ic
al s
et
to
ru
n
El
ec
tr
ic
al
in
stal
lati
o
n
Me
ch
an
ic
al
in
stal
lati
o
n
In
stal
lati
o
n
G
en
e
ral
p
ro
d
u
ct
in
fo
rmatio
n
Safet
y
in
fo
rmatio
n
In
tr
o
d
u
cti
o
n
Figure 21
Evo with front and
top panels removed.