1 of 5
Document part number: 65298R5
Installation Guide
CellSet
MC-Mic, Harley
Kennedy Technology Group, Inc.
email:[email protected]
www.cellset.com
DO NOT ATTEMPT THIS INSTALLATION IF YOU ARE COLORBLIND!
The installation instructions cover both
Pre ‘06
, and
2006 and Later
audio systems.
PRE INSTALLATION
Verify that the bike’s audio system is operational. Check audio and radio functions at both the rider and
passenger positions.
HARNESS INSTALLATIONS
Tools Required
Torx bit for faring and windscreen removal
1/16” wide blade flat screw driver
Thin Needle nose pliers
Micro heat gun or similar (Kennedy part # 35021)
Razor Blade
Remove the bike’s windscreen and the faring. Disconnect the headlamp from the bike’s wiring harness
Locate connector 28A on the rear of the Harley audio unit as shown in Figure 1.
CB
XM
27A
28A
Figure 1. Harley Connector Location
Remove the plugs from connector 28A. The plug attached to the end of the wire harnesses are referred to as
Harley Connector 28B; the wire bundle is Harley Harness 28B
Peel back any protective sheathing on Harley Harness 28B so that at least 6 inches of wire are exposed.
Use a 1/16” wide blade flat screw driver to push the Harley Connector lock-tabs away from the red wedge
lock as shown in Photo 1. Pull the wedge lock up as shown in Photo 2.
The wedge lock should never be
removed from the housing for insertion or removal of the contacts.
