11
DETERGENT AND RINSE AID
Detergent
IMPORTANT:
Use only automatic dishwashing detergent. Hand
dishwashing detergent will produce excessive suds and overflow
out of the dishwasher.
Recommended Detergent Amount
Add recommended amount of detergent to each compartment as
shown and close the detergent lid.
Powders and Gels
Water
Hardness
Soil
Level
Pre-Wash
Compartment
Main Wash
Compartment
Soft
(0-4 grains
per U.S.
gallon)
Light
None
1/2
Normal
None
1/2
Heavy
Full
1/2
Medium
(5-9 grains
per U.S.
gallon)
Light
None
1/2
Normal
1/2
1/2
Heavy
Full*
Full*
Hard
(10-14 grains
per U.S.
gallon)
Light
1/2
Full*
Normal
Full*
Full*
Heavy
Full*
Full*
*Full pre-wash compartment contains 7 tsp (35 mL), and full main
wash cup contains 9 tsp (45 mL).
Premeasured Detergents
Many detergents now come in premeasured forms (gel packs,
tablets, or powder packs). These forms are suitable for all
hardness and soil levels. Always place premeasured detergents in
the main compartment and close the lid.
Using dishwasher detergent tablets and packs have been proven
better than powder, liquid or gel detergents to reduce filming on
your dishes. By using these tablets and packs, over time this will
start to reduce or eliminate white film. Also, by using a rinse aid
you can minimize repeat buildup of white film.
IMPORTANT:
Extremely hard water mineral deposits (15 grains
per U.S. gallon or more) can cause damage to your dishwasher
and make it difficult to achieve good results. A water softener is
recommended to avoid damage and achieve good results. You
may bring your water samples to Sears to check hardness level.
Rinse Aid
IMPORTANT:
Your dishwasher is designed to use a liquid rinse
aid. The use of rinse aids greatly improves drying by allowing
water to drain from the dishes after the final rinse. They also
keep water from forming droplets that can dry as spots or
streaks.
Filling the dispenser
The dispenser holds 5 oz (150 mL) of rinse aid. Under most
conditions this will last 1 to 3 months.
1.
Turn the knob to the REFILL position and remove.
2.
Pour rinse aid into the opening until the indicator points to
FULL. Do not overfill.
3.
Clean up any spilled rinse aid. Spilled rinse aid can create
excessive suds.
4.
Replace the knob and turn to the LOCK position.
NOTE:
Indicator reads correct fill level when door is completely
opened.
Rinse Aid Setting
Your rinse aid dispenser is adjustable. For most water conditions,
the factory setting of 2 will give good results. If you have hard
water and notice calcium buildup on your dishware, you may
want to try a higher setting. If you notice foam in your dishwasher,
use a lower setting.
To adjust the setting
1.
Turn the knob 1/4 turn counterclockwise and remove.
2.
Turn the arrow inside the dispenser to the desired setting.
3.
Replace the knob and turn to the LOCK position.
USE RINSE AID FOR
BETTER DRYING
Lock
Refill
Full
Add