Kenmore 795.74092.41 Series, Руководство по обслуживанию

Страница: 9 / 112

- 9 -
* Ice Fan Assembly Replacement
1) Remove the plastic guide for slides on left side by
unscrewing phillips head screws.
2) Pull out the cover sensor to disassemble by using tools
shown in the figure.
3) Pull out the cover grille to disassemble by using tools
shown in the figure.
4) Put your hand into the inside of grille to disassemble
shown in the figure.
5) Disconnect wire harness of the grille assembly.
6) Remove the Ice fan assembly by loosening all screws.
(1) (2)
(3) (4)
(5) (6)
3-4 Door Alignment
If the level of refrigerator doors is uneven, follow the
instructions below to align the doors:
Turn the leveling legs (CCW) to raise or (CW) to lower the
height of the front of the refrigerator by using flat blade
screw driver or 11/32" wrench. Use the wrench (Included
with the User Manual) to adjust the bolt in the door hinge to
adjust the height. (CW to raise or CCW to lower the height.)
3-5 FAN AND FAN MOTOR
1. Remove the freezer drawer.
2. Remove the plastic guide for slides on left side by
unscrewing phillips head screws.
3. Remove the grille assembly by removing four screws
and pulling the grille assembly forward.
4. Remove the Fan Motor assembly by loosening 3 screws
and disassembling the shroud.
5. Pull out the fan and separate the Fan Motor and Bracket
Motor.
1. Remove all shelf and guide rail on left side.
2. Remove upper and lower Caps by using a flat
screwdriver. And then, remove 2 screws under Caps.
3. Pull out the Multi Duct outward slightly.
4. Disconnect the lead wire on bottom as shown.
5. Grip both side of Multi Duct, pull it out.
6. Remove the Shroud Refrigerator by loosening 4 screws
and disassembling the Multi Duct.
7. Pull out the Fan Motor
3-4-1 FAN AND FAN MOTOR(Freezer Room)
3-4-2 FAN AND FAN MOTOR(Refrigerator Room)
FAN MOTOR
BRACKET
MOTOR
Shroud
Up
Down
Ice Fan Assembly