32
Care & Cleaning
To clean the burner head ignition ports:
Each burner head has a small ignition port located as shown.
Should you experience ignition problems it may be that this port
hole is partially blocked with soil. With the burner head in
place, use a small wire gauge needle or the end of a paper clip
to clear the ignition port (See
Figure 40
).
Important notes:
•
The surface burner heads are secured to the cooktop and
must be cleaned in place on the cooktop.
•
Always keep the surface burner caps in place whenever a
surface burner is in use.
•
When replacing the burner caps, be sure the burner caps
are seated firmly on top of the burner heads.
•
For proper flow of gas and ignition of burners do not allow
spills, food, cleaning agents or any other material to enter
the gas orifice port opening.
Replacing Oven Light (some models)
The interior oven lights are located at the rear of the oven cavity
and are covered with a glass shield. The glass shield must be in
place whenever the oven is in use (See
Figure 41
).
To replace the interior oven light bulb:
Be sure the range is unplugged and all parts
are cool before replacing oven light. Wear a leather-faced
glove for protection against possible broken glass.
1.
Turn electrical power off at the main source or unplug the
range.
2. Remove interior oven light shield by pulling the light straight
out. Do not twist or turn.
3. Replace bulb with a new T-4 type Halogen 25 watt
appliance bulb.
Important note:
Do not allow your fingers to touch the new bulb when replacing.
This will shorten the life of the bulb. Use a paper towel or cotton
glove while handling the new bulb when installing.
4. Replace glass oven light shield.
5. Turn power back on again at the main source (or plug the
appliance back in).
6. Be sure to reset the time of day on the clock.
Figure 41: Replacing the halogen oven light
Содержание 790.3262 Series
Страница 38: ...38 Before You Call ...
Страница 39: ......
