Kenmore 630.1300 Series, Руководство по установке

Страница: 6 / 33

6
Electrical Supply
The customer has the responsibility of ensuring that the
dishwasher electrical installation is in compliance with all
national and local electrical codes and ordinances. The
dishwasher is designed for an electrical supply of 120V,
60 Hz, AC, connected to a dishwasher-dedicated, properly
grounded electrical circuit with a fuse or breaker rated for
15 amps. Electrical supply conductors shall be a minimum
#14 AWG copper wire rated at 75°C (167°F) or higher.
Grounding Instructions
The dishwasher must be properly grounded before
operating. This appliance must be connected to a grounded
metal permanent wiring system, or an equipment grounding
conductor must be run with the circuit conductors and
connected to the equipment grounding terminal or lead on
the dishwasher. Make sure that the dishwasher is connected
to a suitable ground in compliance with all local codes
or, in the absence of a local code, with the NATIONAL
ELECTRICAL CODE in the United States or the CANADIAN
ELECTRIC CODE C22.1-latest edition in Canada as well as
any provincial/state or municipal or local codes that apply.
Electrical Connection
The dishwasher electrical supply junction box and
dedicated receptacle must be mounted in an accessible
cabinet adjacent to the dishwasher (do not mount the
junction box or receptacle behind the dishwasher). You
will need a 4
1
/
4
” x 2” (10.8 x 5.1cm) opening throught
the cabinet in order to pass the junction box through. If
the opening is made through wood, sand it smooth. If the
opening is made through metal, use the included protective
grommet or other approved method to protect wiring from
damage.
Use the four screws (not supplied) to securely mount the
junction box so that it can be easily accessed. The electrical
supply can be connected in two ways:
Method A - Three prong plug and receptacle
Use the included three-prong plug and junction box to
connect to a dedicated household receptacle. Make sure
the household receptacle meets the electrical supply
requirements as well as national and local codes.
Method B - To permanently connect to household or ield
wiring:
1. Remove the dishwasher electrical supply junction box
cover and connect to the power supply cord from the
house installation.
2. Remove 2” to 3” (5.1 - 7.6cm) of the outer casing of
the household or ield supply wiring as shown below.
Remove 3/8” to 1/2” (1 - 1.3cm) of the insulation from
each wire.
Dishwasher Electrical Rating
Volts Hertz Amperes Watts
120 60 15
1,450
(max)
Dedicated
Receptacle
or
Field Wiring
Dishwasher
Electrical Supply
Junction Box
Electric cord with
junction box and
three prong plug
are included
with dishwasher
ELECTRICAL REQUIREMENTS
12
3/8" - 1/2"
(10mm - 13mm)
2" - 3"
(51mm - 76mm)
Avoid Electrical Shock Hazard
Do not work on an energized circuit. Doing so could result
in serious injury or death. Only qualiied electricians
should perform electrical work. Do not attempt any work
on the dishwasher electric supply circuit until you are
certain the circuit is de-energized.
WARNING
Avoid Fire Hazard
Make sure electrical work is properly installed. Only
qualiied electricians should perform electrical work.
WARNING
5.1cm - 7.6 cm
1cm - 1.3 cm