Kenco KL9000, Руководство по эксплуатации

Страница: 5 / 18

KENCO Kenlift
®
Operation Manual
Section III. Identification of Major Components
Section IV. Setup
A. Check Kenlift
®
for any signs of damage incurred during shipping.
B. Record model and serial #of assembly and components.
C. Check that all pad bolts are tight.
D. DO NOT OVER TIGHTEN PAD ANGLE BOLTS. PAD ANGLE MUST HAVE
(LIMITED) ROTATIONAL FREEDOM AT THIS POINT.
E.
Check that all identification and warning labels are present.
F. Attach Kenlift
®
to hoist.
1. Use as few rigging components (shackles, slings, chain, etc.) as possible.
2.
ALL RIGGING COMPONENTS MUST HAVE A WORKING LOAD LIMIT THAT IS
EQUAL TO OR GREATER THAN THE COMBINED WEIGHT OF INTENDED
LOAD PLUS THE Kenlift
®
.
LIFT BAIL
PAD ANGLE BOLTS
PAD BOLTS
GRIP PAD
ACTUATOR
(INTERNAL)
ARM
PAD ANGLE
LEG