www.kenall.com | P: 800-4-Kenall | F: 262-891-9701 | 10200 55th Street Kenosha, Wisconsin 53144, USA
This product complies with the Buy American Act: manufactured in the United State swith more than 50% of the component cost of US origin It may be covered by patents
found at www.kenall.com/patents. Content of specification sheets is subject to change; please consult www.kenall.com for current product details. ©2019 Kenall Mfg.Co.
1
INSTALLATION INSTRUCTIONS
F-4826-090418
MRSDL4L / M2SRDL4L SERIES
MEDMASTER ENVELA
®
REGRESSED DOWNLIGHT
NEW CONSTRUCTION- DRYWALL CEILING
–
RECOMMENDED CEILING CUTOUT- 4.125" SQUARE
FIGURE 1
Patient Room & Surgical Suite Luminaires
THE ENVELA DOWNLIGHT CONTAINS SENSITIVE ELECTRONICS. TAKE CARE TO AVOID DAMAGE BY IMPROPER HANDLING OR STATIC
ELECTRICITY DISCHARGE (ESD). EITHER TYPE OF DAMAGE COULD RENDER THE SYSTEM INOPERABLE OR CAUSE LATENT FAILURE.
LED
Note- 28L or 28T fixtures must be installed minimum
24" center to center, 12" from wall and have 1/2"
clearance above the trim.
1.
Loosen locking screws to extend hanger bars. See
Figure 1.
2.
Align bottom of hanger bar tabs to bottom of joist.
3.
Secure luminaire hanger bars using nails or screws.
4.
Position luminaire as required and lock position by
tightening locking screws.
5.
Remove junction box cover.
6.
Remove appropriate 1/2" knockout(s) and connect
to electrical service.
7.
Wire per wiring diagram using approved wire
connectors. See Figure 2.
8.
Replace junction box cover.
LOCKING SCREW
ALIGN TO BOTTOM OF JOIST
COPPER GROUND WIRE
LED
DRIVER
GREEN
CONNECT GROUND WIRE TO GREEN
AND COPPER GROUND WIRES
WHITE
CONNECT COMMON SUPPLY WIRE TO WHITE WIRE
BLACK
CONNECT HOT SUPPLY WIRE (120-277V) TO BLACK WIRE
GREY
CONNECT (-)10V FROM DIMMER TO GREY WIRE (OPT)
VIOLET
CONNECT (+)10V FROM DIMMER TO VIOLET WIRE (OPT)
FIGURE 2
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions
should always be followed, including the following:
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE
WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF
THE PRODUCT AND THE HAZARDS INVOLVED.
CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODE
D’INSTALLATION PERTINENT, PAR UNE PERSONNE QUI
CONNAÎT BIEN LE PRODUIT ET SON FONCTIONNEMENT
AINSI QUE LES RISQUES INHÉRENTS.
DISCONNECT POWER TO ALL CIRCUITS BEFORE WIRING FIXTURE.
INSTALL IN ACCORDANCE WITH ALL NATIONAL, STATE, AND
LOCAL CODES. DO NOT CONNECT TO AN UNGROUNDED
SUPPLY. READ ALL FIXTURE MARKINGS AND LABELS TO
ENSURE CORRECT INSTALLATION OF FIXTURE. SUPPLEMENTAL
INSTRUCTIONS MAY BE LOCATED ON THE FIXTURE, IN ADDITION
TO THIS INSTRUCTION SHEET, REGARDING ORIENTATION, OR
MOUNTING RESTRICTIONS.
SAVE THESE INSTRUCTIONS