Kemper 345plus, Руководство оператора

Страница: 68 / 126

Detaching the Rotary Harvesting Unit
KM00321,0000193 -19-27JUN12-1/1
KM00321,0000192 -19-08AUG12-1/1
Install Front Jackstands (Rotary Harvesting
Units for KRONE Forage Harvesters Only)
Before detaching the rotary harvesting unit, install front
jackstands (A) on both sides.
CAUTION: When working underneath the rotary
harvesting unit, it must be supported securely.
A—Jackstand
KM1002318
—UN—18JUN12
Detach Rotary Harvesting Unit
1. Lower the rotary harvesting unit onto a flat level
surface.
2. Shut off the forage harvester's engine, remove the key
from the ignition and apply the park brake.
3. Disconnect the electrical connector and hydraulic
couplers (A) from the forage harvester and store them
in provided bracket (B).
4. Pull off the drive shaft.
5. At left and right, lower jackstands (C) and lock them
at a suitable height. To do this, pull out spring-loaded
pin (D) and let it re-engage when the jackstand has
reached the correct height.
NOTE: Leave the rotary harvesting unit standing at
a height that allows the unit to be reattached
to a forage harvester at a later time. Never
select a height that is too low.
6. Disengage the lock on the rotary harvesting unit's
attaching frame.
7. Start the forage harvester, lower the feed roll housing
further and drive out of the rotary harvesting unit's
attaching frame.
KM1001
1
16
—UN—18FEB10
KM1002329
—UN—10AUG12
A—Hydraulic Couplers
B—Bracket C—Jackstand
D—Pin
25-1 031519
PN=68