３２
19. Part replacement
The globe and the temperature/humidity sensor unit of this p
roduct can be replaced. Be careful not to allow dust or wate
rdrops to enter the inside of the main unit when replacing.
A correct measurement cannot be performed if the globe of this
product is dented or damaged. Replace the globe if it is damaged.
Refer to page 36 for the purchase of the globe.
And refer to the manual included with the Replacement globe for
more details on how to replace it.
Replace the temperature/humidity sensor unit if it is damaged,
such as when a malfunction of the temperature/humidity sensor
occurs or a correct measurement value is not displayed.
Refer to page 36 for the purchase of the temperature/
humidity sensor.
And refer to the manual included with the Replacement
temperature/humidity sensor for more details on how to replace it.
Request
Correct measurements may not be possible if the sensor element is touched. Be sure to
install the sensor without touching it.
Be sure to remove batteries before replacing the temperature/humidity sensor unit.
The shaft may be broken if the globe is turned too hard when installing it. Be sure to Install
the globe at the position where the screw stops and the connections between the sensor
cap and the globe are aligned
as a guide. (Refer to page 31.)
Pickup inspection is necessary when a calibration certificate is required.
Please contact your KEM representative.
Warning
If the temperature/humidity sensor is not installed correctly, JIS
standard IP65 (dustproof and waterproof performance) will
not be satisfied.
Warning
The temperature/humidity sensor may be damaged if an error
occurs after replacing the temperature/humidity sensor unit.
Please contact your KEM representative.
How to replace the globe
How to replace the temperature/humidity sensor
