Kellfri 35-XKH145, Инструкция по эксплуатации, Страница: 3 / 36

3
Table of Contents >>
INTRODUCTION
Thank you for choosing a product from Kellfri AB. Compliance with the safety instructions, operating
manual and sound common sense will guarantee many years of enjoyment using the product.
Kellfri's equipment and products are aimed at self-employed farmers, horse enthusiasts and other
country-dwellers who have stringent performance demands.
PRODUCT INFORMATION
The XKH145/185 flail mower is a powerful machine for those of you who have high performance
demands but are looking for a smaller and more versatile machine. The working width
is 1.45 m/1.85 m, making it practical for flailing, topping or cutting small or medium-sized grasslands
and grassed areas. The flail mower has a coarse-toothed welded counter bar in the chassis to break
up the grass more effectively.
The cutting height is adjusted by the support roller and skids. The adjustable support roller
guarantees a correct cutting height on uneven ground. The cutting height can be adjusted between
0-80 mm, enabling you to cut the grass close to the ground and thus achieve a more level result. The
grass is evened out and the remnants moulder away faster. The support roller has a scraping iron to
keep the roller free from cut material.
The front of the flail mower is fitted with steel plates that adapt to the substrate and protect both
the tractor and the surroundings from stone chipping and grass spray.
The flail mower is fitted as standard with hammer flails. The flail mower is also adapted for Y-flails,
which can be purchased additionally (not included).
This flail mower is equipped as standard with hydraulic side shift adjustment, which enables you to
shift the machine to the left or right. The side shift adjustment means that you can cut at the side of
your tractor and thereby reach areas that would otherwise be difficult to reach.
The hydraulic side shift adjustment enables you to drive with just one pair of wheels in the uncut
area and cut closer to ditches, fences, etc.
The mower has an openable flap. You open the flap when you know you are cutting or topping
ground that generates a higher flow of material. This enables you to drive freely under the same
conditions as with a closed flap and a normal flow of material. You save on fuel and reduce wear on
the belts, and you can also operate at a higher speed, as the grass does not become twisted around
the roller. The grass is also spread more evenly.
TECHNICAL DATA 35-XKH145 35-XKH185
Length x width x height 1620 x 820 x 630 mm 2020 x 820 x 630 mm
Working width 1450 mm 1850 mm
Operating height 0 - 80 mm 0 - 80 mm
Weight 355 kg 392 kg
PTO shaft Standard Standard
Power requirement 25-60 hp 35-65 hp
Flails, hammer 18 pcs 22 pcs
Openable flap Yes Yes
Side shift adjustment Hydraulic Hydraulic
RPM 540 540
3-point linkage Cat. 1 & 2 Cat. 1 & 2
Gearbox - transmission oil 80W-90 1.2 L 1.2 L