Kellfri 35-SKL145, Руководство пользователя

Страница: 13 / 24

13
Table of contents >>
SERVICE INTERVAL
Flails Before each run Replace all broken flails. Sharp flails gives
better result.
When replacing any flails ensure that the
bolts are firmly tightened.
During operation Always listen to any unsual noise
After each run Check
Gearbox Before each run Check oil level
Transmission oil
80W-90
After every 50 operation hours First oil change
After every 100 operation hours
or once a year
Oil change
Amount: 1,0 L
Rotor After every 20 operation hours Lubricate
Belts After 1 hour use
Regularly
Belt tension; check and tighten
When the belt is pressed the belt should
move about 20 mm (10mm each side)
Hydraulic Before each run Check all hydraulic tubes are intact, not
broken, right connected and not leaking.
Machine After each run Rinse soil and grass with water id necessary
TROUBLESHOOTING/ ERROR MEASURE
Flail mower cuts uneven or poorly Check that all flails are undamaged and properly tightened.
Adjust the support roller and make sure it’s properly mounted
Check and tighten all belts
The cutting sound change Check the roller
Check the tensioning of the V-belt
Check the flails
Excessive vibrations Check the flails and the roller
The hydraulic is not working Check all tubes and couplings
Installation of hammer flail
80 mm
40 mm
WARNING!
Never use different types of flail on the machine.
Always check the tightening torque on each flail after replacing.
Make sure that bolts/nuts are well tightened and cannot come loose.