Easy Fountain Instructions
45019L Acre Falls
STAGE 1
STAGE 2
STAGE 3
STAGE 4
STAGE 5
STAGE 6
Please note the transformer will get hot while in use, this is normal.
Please read the assembly and pump operating instructions carefully and observe the safety
instructions.
Thread the long transformer wire through the opening in the back of the fountain. Push the cable
with 2 pins into the transformer and screw over the plastic collar.
ELECTRICAL SAFETY:
If outdoors the outlet must be
waterproof. We recommend the use of a residual current device
(GFI) Ground Fault Interrupter (available from all good D.I.Y.
stores) when connecting the fountain to the electric supply.
PUMP FLOW:
The pump flow
can be adjusted with the
regulator, this is found on the
inlet of the pump. We
recommend starting with the
flow regulator fully open and
then adjusting down if required.
Position the water feature onto a secure and level surface.
Following the diagram above, fix the top urn section of the feature onto the log section and secure
into position.
Position the pump inside the reservoir in the bottom urn as shown in the image and connect the
LED wire to the cable extending from the pump. Connect the internal water tubing to the pump
outlet.
Carefully fill the fountain with sufficient water taking care to ensure the pump is fully submerged.
Connect the plug to your mains outlet.
The transformer should never be submerged or stood in water.
www.kelkay.com
