Easy Fountain Instructions
45012L - Slate Crag Falls
STAGE 1
Position the base section of the feature onto a secure and level location.
STAGE 2
STAGE 3
STAGE 4
STAGE 5
STAGE 7
Thread the transformer wire through the access cavity and push the cable with 2 pins into the
transformer and screw over the plastic collar.
STAGE 6
Fill the fountain with sufficient water to ensure that the pump is fully submerged.
Please read the assembly and pump operating instructions carefully and observe the safety
instructions.
Following the diagram above, fix the top section onto the base of your water feature and lock it into
place.
Following the diagram above reach into the access cavity at the back of the water feature and
carefully bring out the LED light cables and the internal water pipe.
Connect the plug to your mains outlet.
The transformer should never be submerged or stood in water.
Please note the transformer will get hot while in use, this is normal.
Connect the LED light cables that from the inside of the water feature to the cables which extend
from the water pump. Connect the internal water pipe onto the pump outlet.
ELECTRICAL SAFETY:
If outdoors the outlet must be
waterproof. We recommend the use of a residual current device
(GFI) Ground Fault Interrupter (available from all good D.I.Y.
stores) when connecting the fountain to the electric supply.
PUMP FLOW:
The pump flow
can be adjusted with the
regulator, this is found on the
inlet of the pump. We
recommend starting with the
flow regulator fully open and
then adjusting down if required.
www.kelkay.com
