EN | LED Floodlight Instruction
Attention: Please read the following instructions carefully to ensure that mounting operation will be carried out
in the right way .These instructions should be properly preserved for future reference.
Ⅰ
.Main construction Data
Type:
Rate
d
Pow
er:
Supply
Current
Powe
r
factor
protective
shield
Weigh
t
Maximu
m
projected
area
Dimensions
Remark:
1524222
10W Max.60
mA
＞
0.5
98.4*77.4*4m
m
0.394k
g
151.3cm
2
124*56.5*122m
m
Electric shock
protection class: I
External light
protection class:
IP65
Rated voltage:
220-240V~
50/60Hz
Mounting
height:<3m
Universal for
operating
position.
1524226
50W Max.220
mA
＞
0.9
202.4*154.4*4
mm
0.521k
g
225.8cm
2
159*54*142mm
1524224
30W Max.130
mA
＞
0.9
172.8*132.8*4
mm
0.944k
g
453.4cm
2
229*59*198mm
Ⅱ
.Safety instructions
1. Before mounting and maintenance please make sure that the electrical supply has been switched off to
avoid electric shock.
2. The lamp must be earthed.
3. The power cord should be VDE-certified H05RN 3x1.0mm
2
or H07RN-F 3x1.0mm
2
waterproof cable.
4. The lamp can be mounted on normally flammable surfaces.
5. The external flexible cable or cord of this luminaire cannot be replaced. If the cord is damaged, the
luminaire shall be destroyed.
Ⅲ
. Assembly
1. Turn off the power. (see Fig 01)
2.Determine the installation location and mark the wall. (see Fig 02.1)
3. Drill holes with an electric drill at the marked locations.(see Fig 02.2)
4. Plugs into wall mounting holes with included plastic expansion.(see Fig 02.3)
5. Use the tool to fasten the included screws, flat washers and fixing brackets to the mounting holes.(see Fig
02.4)
6.Tighten the screws on the mounting bracket with a tool.(see Fig 02.5)
7. The plug is connected to the power socket.(see Fig 02.6)
8. Switch on the power for use.(see Fig.03)
Ⅳ
.Operation
1. The lamp is only suitable for mounting on the wall. The installation height must be less than 3m.(see Fig.
03)
2. The lamp can be tilted down 90
0
and upward 45
0
.(see Fig.03)
CAUTION:
The light source of this luminaire is not replaceable, when the light source reaches its end of life the whole
luminaire shall be replaced.
This marking indicates that this product should not be
disposed with other household wastes throughout the EU. To
prevent possible harm to the environment or human health
from uncontrolled waste disposal, recycle it responsibly to
promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems
or contact the retailer where the product was purchased. They
can take this product for environmental safe recycling.
