Section 4: Command reference
Series 2200 Programmable DC Power Supplies Reference Manual
4-26
2200S-901-01 Rev. C / March 2016
[SOURce:]VOLTage:RANGe
This command limits the maximum voltage that can be
programmed on the power supply. This command corresponds to
the front-panel Max Voltage setting that can be found under the
Protection submenu. This function is different from OVP, since it
cannot turn the output off.
Group
Source
Syntax
[SOURce:]VOLTage:RANGe {<voltage>|MIN|MAX|DEF}
[SOURce:]VOLTage:RANGe?
Related
Commands
[SOURce:]VOLTage:PROTection[:LEVel]
(on page 4-24)
[SOURce:]VOLTage:PROTection:STATe
(on page 4-25)
Arguments
<voltage>::=<NRf><units>
where:
<NRf> is a flexible decimal that sets the maximum output voltage,
ranging from 0 to the maximum nameplate voltage
<units>::={V|mV|kV}
MIN:
sets the voltage limit to the minimum value (0 V).
MAX:
sets the voltage limit to the maximum value which is slightly
higher than the maximum nameplate voltage.
DEF:
sets the voltage limit to the default value, which equals MAX.
Returns
<NR2>
is the voltage limit in volts.
Examples
VOLT:RANG 3.2V
VOLT:RANG?
might return 3.2, which would be the maximum
programmable voltage in volts.