Series 2200 Programmable DC Power Supplies Reference Manual
Section 2: General operation
2200S-901-01 Rev. C / March 2016
2-21
Recall the power supply operating parameters at power on
The Save Last control determines whether the power supply saves its most recent settings, such as
voltage and current, and restores these settings at power on. If you set this control to
Off
then the
power supply returns to the default settings at power on. If you select
On
, the power supply will
restore the state to that which was in use before the power was last turned off.
To enable or disable this control:
1. Press
Shift
and then
Menu (1)
to access the configuration menus.
2. Use the arrow keys to select
>User
.
3. Press
Enter
.
4. Use the arrow keys to select
>Save Last
.
5. Press
Enter
.
6. Use the arrow keys to select
>On
or
>Off
.
7. Press
Enter
.
8. Press
Esc
to exit the menu system.
Wait 3 seconds after changing the settings to allow the settings to be completely stored before
powering off the instrument
The default value for the Save Last control is On.
Setting the key sound
The Key Beep control can switch on or off the beeper that sounds when you press any button or
press any key.
To set the key sound:
1. Press
Shift
and
Menu (1)
to access the configuration menus.
2. Use the arrow keys, numeric keypad, or navigation wheel to select
>User
.
3. Press
Enter
.
4. Use the arrow keys to select
>Key Beep
.
5. Press
Enter
.
6. Use the arrow keys to select
>On
or
>Off
.
7. Press
Enter
.
8. Press
Esc
to exit the menu system.
The default value for the Key Beep control is Off.
