Chapter 3
16
Configuring the Device Driver
To configure the device driver for the KUSB-3116 module, perform
the following steps:
1.
If you have not already done so, power up the host computer and
all peripherals.
2.
From the Windows Start menu, select
Settings|Control Panel
.
3.
From the Control Panel, double-click
Open Layers Control
Panel
.
The Data Acquisition Control Panel dialog box appears.
4.
Click the KUSB-3116 module that you want to configure, then
click
Advanced
.
The Control Panel dialog box appears.
5.
If you are using differential analog input channels, it is
recommended that you select the
10k Ohm Resistor
Terminations
checkbox for each analog input channel on the
module. This ensures that 10 k
Ω
of bias return termination
resistance is used for the analog input channels. (This is the
default configuration.) Bias return termination resistance is
particularly useful when your differential source is floating.
If you are using single-ended analog input channels, clear the
checkbox for each analog input channel so that bias return
resistance is not used.
6.
If required, select the digital input line(s) that you want to use for
interrupt-on-change operations. When any of the selected lines
changes state, the module reads the entire 16-bit digital input
value and generates an interrupt.
7.
Click
OK
.
8.
If you want to rename the module, click
Edit Name
, enter a new
name for the module, then click
OK
. The name is used to identify
the module in all subsequent applications.
9.
When you are finished configuring the module, click
Close
.
Содержание KUSB-3116
