Checking Your Installation
3-11
4. Make sure the base address switch is properly set (refer to “Setting
the Base Address” on page 3-9).
5. Insert and secure the board.
6. Replace the computer cover.
7. Continue with the next section, “Checking Your Installation.”
Checking Your Installation
The ability to start the DriverLINX DAS-TC/B Data Logger utility, which
is available only after you install DriverLINX, verifies that DriverLINX
and the board are installed and configured satisfactorily. Do the
following:
1. Click the Windows 95/98/NT
Start
tab.
2. In the
Start
menu, click
Programs
.
3. Find the
DriverLINX
→
Test Panels
folder, you should find the
DAS-TC/B Data Logger
entry.
4. Click on the
DAS-TC/B Data Logger
entry. The initial DAS-TC/B
Data Logger screen should appear if the installation is satisfactory.
Refer also to the
DriverLINX Installation and Configuration Guide
and
Using DriverLINX with Your Hardware—Keithley DAS-TC/B
manuals.
After you configure and check your installation, you can attach
accessories as needed and wire the appropriate signals to the board. Refer
to Section 4, “Cabling and Wiring,” for instructions.
