![background image](http://html2.mh-extra.com/html/keithley/6220/6220_reference-manual_4055087285.webp)
Model 6220/6221 Reference Manual
Remote Operations 10-21
Return to
Figure 10-3
IEEE-488, Ethernet (6221 only), and RS-232 connector locations
2.
Tighten the screws securely, making sure not to over-tighten them.
3.
Connect any additional connectors from other instruments as required for
your application.
4.
Make sure the other end of the cable is properly connected to the controller.
Most controllers are equipped with an IEEE-488 style connector, but a few
may require a different type of connecting cable. See your controller’s instruc-
tion manual for information about properly connecting to the IEEE-488 bus.
Primary address
The Model 622x ships from the factory with a GPIB address of 12. When the
instrument powers up, it momentarily displays the primary address. You can set
the address to a value of 0-30. Do not assign the same address to another device
or to a controller that is on the same GPIB bus.
Usually controller addresses are 0 or 21 but see the controller’s instruction manual
for details. Make sure the address of the controller is the same as that specified in
the controller’s programming language. To make sure the unit’s interface is prop-
erly selected and configured or to check or change the setting, see
selection and configuration,” on page 10-3
.
NOTE
You can only have 15 devices connected to an
IEEE-488 bus, including the controller. The maxi-
mum cable length is either 20 meters or two
meters times the number of devices, whichever is
less. Not observing these limits may cause errat-
ic bus operation.
IEEE-488
Connector
Ethernet
Connector
(6221 Only)
RS-232
Connector
WARNING:
NO INTERNAL OPERATOR SERVICABLE PARTS,SERVICE BY QUALIFIED PERSONNEL ONLY.
WARNING:
NO INTERNAL OPERATOR SERVICABLE PARTS,SERVICE BY QUALIFIED PERSONNEL ONLY.
CAUTION:
FOR CONTINUED PROTECTION AGAINST FIRE HAZARD,REPLACE FUSE WITH SAME TYPE AND RATING.
CAUTION:
FOR CONTINUED PROTECTION AGAINST FIRE HAZARD,REPLACE FUSE WITH SAME TYPE AND RATING.
MADE IN
U.S.A.
INTERNALLY
SWITCHED
1 AMP MAX.
HI
CABLE
GUARD
105Vpk
LO
105Vpk
250Vpk
OUTPUT
CAT I
IEEE-488
(CHANGE IEEE ADDRESS
WITH FRONT PANEL MENU)
ETHERNET
10/100 BaseT
10bT
100bT
DIGITAL I/O
RS-232
TRIGGER
LINK
LINE FUSE
SLOWBLOW
1.6A, 250V
LINE RATING
100-240VAC
50, 60Hz
120VA MAX.
250Vpk
105Vpk
LO
GUARD
INTERLOCK
!
!
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com
Содержание 6220
Страница 16: ...Test Equipment Depot 800 517 8431 99 Washington Street Melrose MA 02176 TestEquipmentDepot com...
Страница 24: ...Test Equipment Depot 800 517 8431 99 Washington Street Melrose MA 02176 TestEquipmentDepot com...
Страница 403: ...A Specifications Test Equipment Depot 800 517 8431 99 Washington Street Melrose MA 02176 TestEquipmentDepot com...
Страница 453: ...Test Equipment Depot 800 517 8431 99 Washington Street Melrose MA 02176 TestEquipmentDepot com...