Keithley 3700A Series, Справочное руководство

Страница: 794 / 936

Series 3700A System Switch/Multimeter Reference Manual Section 11: TSP command reference
3700AS-901-01 Rev. D/June 2018 11-415
trigger.timer[N].EVENT_ID
This constant specifies the trigger timer event number.
Type TSP-Link accessible Affected by Where saved Default value
Constant Yes
Usage
eventID = trigger.timer[ N ].EVENT_ID
eventID
The trigger event number
N
Trigger timer number (1 to 4)
Details
This constant is an identification number that identifies events generated by this timer.
Set the stimulus of any trigger object to the value of this constant to have the trigger object respond to
events from this timer.
Example
scan.trigger.channel.stimulus = trigger.timer[2].EVENT_ID
Sets the trigger stimulus of
the channel event detector
to trigger timer 2 event.
Also see
None
trigger.timer[N].overrun
This attribute indicates if an event was ignored because of the event detector state.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (R) Yes Instrument reset
Recall setup
Trigger timer N clear
Trigger timer N reset Not applicable false
Usage
overrun = trigger.timer[ N ].overrun
overrun
Trigger overrun state (
true
or
false
)
N
Trigger timer number (1 to 4)
Details
This command indicates if an event was ignored because the event detector was already in the
detected state when the event occurred.
This is an indication of the state of the event detector built into the timer itself. It does not indicate if
an overrun occurred in any other part of the trigger model or in any other construct that is monitoring
the delay completion event. It also is not an indication of a delay overrun.