Keithley 3700A Series, Справочное руководство

Страница: 401 / 936

Section 11: TSP command reference Series 3700A System Switch/Multimeter Reference Manual
11-22 3700AS-901-01 Rev. D/June 2018
Example
testData = dmm.makebuffer(50)
testData.appendmode = 1
dmm.measurecount = 3
dmm.measure(testData)
printbuffer(1,testData.n, testData )
testData.clear()
print("Readings in buffer after clear ="
.. testData.n)
dmm.measurecount = 3
dmm.measure(testData)
printbuffer(1,testData.n, testData )
Create a reading buffer named
testData
and
enable append mode for it. Take three readings and
store them in
testData
, and then view the
readings.
Output:
3.515871341e-07, 5.596728126e-07,
3.944283032e-07
Next, clear the data and verify there are no readings
in buffer.
Output:
Readings in buffer after clear = 0
Store three new readings in the buffer and view
those when done.
Output:
4.923509754e-07, 3.332266330e-07,
3.974883867e-07
Also see
Reading buffers (on page 6-7, on page 6-1)
bufferVar.clearcache()
This function clears the cache.
Type TSP-Link accessible Affected by Where saved Default value
Function Yes
Usage
bufferVar .clearcache()
bufferVar
The reading buffer
Details
This function clears all readings from the specified cache.
If you run successive operations that overwrite reading buffer data, the reading buffer may return
stale cache data. This can happen when initiating successive scans without reconfiguring the scan
measurements. Watch for this when running Lua code remotely on more than one node, because
values in the reading buffer cache may change while the Lua code is running.To avoid this, you can
include explicit calls to the
bufferVar .clearcache()
function to remove stale values from the
reading buffer cache.
Example
testData.clearcache()
Clears the reading buffer cache for a
user-defined buffer named
testData
.
Also see
bufferVar.cachemode (on page 11-19)
Reading buffers (on page 6-7, on page 6-1)