![background image](http://html2.mh-extra.com/html/keithley/2657a/2657a_reference-manual_4007750540.webp)
Model 2657A High Power System SourceMeter® Instrument Reference Manual
Section 7: TSP command reference
2657A-901-01 Rev. B/December 2012
7-227
Details
The SMU will automatically clear all the event detectors when the
smu
X
.trigger.initiate()
function is
executed. This function should be called after the sweep is initiated.
A common example of when this function can be used is when you want the SMU to immediately perform an
action the first time through the trigger model even if a programmed trigger event does not occur.
This function can also be used to start actions on the SMU in case of a missed trigger event.
Example
smua.trigger.arm.set()
Sets the arm event detector to the
detected state for SMU channel A.
Also see
(on page 7-234)
(on page 7-235)
(on page 7-245)
smuX.trigger.arm.stimulus
This attribute selects the event that will cause the arm event detector to enter the detected state.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (RW)
Yes
SMU reset
Instrument reset
Recall setup
Not saved
0
Usage
eventID
= smu
X
.trigger.arm.stimulus
smu
X
.trigger.arm.stimulus =
eventID
eventID
Event that triggers the arm detector
X
Source-measure unit (SMU) channel (for example,
smua.trigger.arm.stimulus
applies to SMU channel A)
Содержание 2657A
Страница 3: ......