![background image](http://html2.mh-extra.com/html/keithley/2657a/2657a_reference-manual_4007750295.webp)
Section 6: Instrument programming
Model 2657A High Power System SourceMeter® Instrument Reference Manual
6-46
2657A-901-01 Rev. B/December 2012
Example: Retrieve the content of a script with scriptVar.list()
test.list()
Request a listing of the source of
test
.
An example of the possible instrument output is
shown here (note that the
loadscript
and
endscript
commands are included).
Output:
loadscript scriptVarTest
listTones = {100, 400, 800}
for index in listTones do
beeper.beep(.5, listTones[index])
end
endscript
Example: Retrieve the content of a script with scriptVar.source
print(test.source)
Request a listing of the source of the script named
test
. The
loadscript
and
endscript
commands are not included.
An example of the possible instrument output is:
listTones = {100, 400, 800}
for index in listTones do
beeper.beep(.5, listTones[index])
end
Delete user scripts from the instrument
In most circumstances, you can delete a script using
script.delete()
(as described in
(on page 6-9)), and then turn the instrument off and back on again. However, if you
cannot turn the instrument off, you can use the following steps to completely remove a script from the
instrument.
When you completely remove a script, you delete all references to the script from the run-time
environment, the
script.user.scripts
table, and nonvolatile memory.
To completely remove a script:
1.
Remove the script from the run-time environment.
Set any variables that refer to the script to
nil
or assign the variables a different value. For example, to remove the script
"beepTwoSec"
from the run-time environment, send the following code:
beepTwoSec = nil
2.
Remove the script from the script.user.scripts table.
Set the name attribute to an empty
string (
""
). This makes the script nameless, but does not make the script become the anonymous
script. For example, to remove the script named
"beepTwoSec"
, send the following code:
script.user.scripts.beepTwoSec.name = ""
3.
Remove the script from nonvolatile memory.
To delete the script from nonvolatile memory,
send the command:
script.delete("
name
")
Where
name
is the name that the script was saved as. For example, to delete
"beepTwoSec"
,
you would send:
script.delete("beepTwoSec")
Содержание 2657A
Страница 3: ......