Keithley 2657A, Справочное руководство, Страница: 291 / 805

Section 6: Instrument programming Model 2657A High Power System SourceMeter® Instrument Reference Manual
6-42 2657A-901-01 Rev. B/December 2012
Figure 98: Create a new script with the name of an existing script
Rename a script
You can rename a script. You might want to rename a script if you need to name another script the
same name as the existing script. You could also rename an existing script to be the autoexec script.
To change the name of a script, use the command:
scriptVar
.name = "
renamedScript
"
Where:
scriptVar
= The global variable name
"
renamedScript
" = The new name of the user script that was referenced by the
scriptVar
global variable
After changing the name, you need to save the original script to save the change to the name
attribute.
For example:
beepTwoSec.name = "beep2sec"
beepTwoSec.save()
Run the
beep2sec
script using the following command:
script.user.scripts.beep2sec()
Name Value
reference to script named
beepTwoSec
script.user.scripts table
beepTwoSec
reference to an unnamed
script
Global variables
Scripts in the runtime environment
reference to script named
beepTwoSec
No Autorun
beeper.enable = 1
beeper.beep(2, 2400)
script name
source
No Autorun
script name
source
beepTwoSec
beeper.enable = 1
beeper.beep(2, 1200)
beepTwoSec
beepTwoSec1200
Note that the
script.user.scripts
table
entry referencing beepTwoSec was removed and
a new entry for beepTwoSec has been added