Factory Preset Guides
Notes about the Preset Guide images:
●
If a data source is not accounted for in the preset guide image, this means it is
disabled. For Example: If one of the Pads only shows note names and not pressure
CC#s, assume that the pressure data is turned off and will not output as MIDI data,
even in CoMA mode.
MIDI Output
Preset 1
: (Drum C1-D#2 / Serato)
Preset 2
: (Drum E2-G3)
Preset 3
: (Drum G#3-B4)
Preset 4
: (Drum C5-D#6)
Presets 1-4 are the same except the pad notes increment up as the preset # increases. So
the pad notes on preset 1 are shown below from C1-D#2, preset 2 are from E2-G3, preset 3
are from G#3-B4, and preset 4 are from C5-D#6.
These presets are in Drum Mode and don’t use banks. Rotaries are set to use Direction
instead of Location. Pass Thru Widths for the rotaries are set to 127. The Pad X/Y Return
values are set to 63. Velocity response is enabled for all notes on the Pads; velocity is fixed
at 127 for notes on other sensors.
Our Serato Template uses Presets 1-3 and is included in the QuNeo Software Installer.
12