P a g e
6 | 13
The new cable provided with the ULINK
pro
unit may have pin 7 filled with a plastic plug. If so, remove the plastic
plug before connecting to the Kinetis target. This is easily done with a sharp needle. Merely pry the plastic pin out.
NOTE:
Do not remove or disturb the battery. The ULINK
pro
will not operate if battery power is lost.
With the 20 to 10 pin adapter installed on the ULINK
pro
unit and any pin plugs removed, connect the cable to the
J9-JTAG
connector (shown circled below). Note the location of Pin 1 will correspond to Pin 1 on the connector (the
plug is not keyed).
When using OpenSDA, the computer is connected to the SDA-USB port. Ensure this is NOT connected when the
ULINK
pro
is used. Instead, insert the USB cable in the USB port (as shown above). This provides power to the K64F
board. Once the JTAG unit is connected to the FRDM-K64F board, install the WNC-Shield board and make the
necessary connections (e.g., antenna, power).
Plug that needs to
be removed