HIZO G14 Pizza Oven
–
User Manual
Page
8
of
12
Last Updated 19/07/2022 3:47 PM
4. Connect the LPG regulator hose to the gas tank
CONNECTING THE LIQUID PROPANE GAS CYLINDER
1. Ensure the cylinder valve is in the OFF position.
4.1.
Make sure the burner valve is in OFF position.
4.2
. Inspect the valve connections, port and regulator assembly. Remove debris and inspect
the hose for damage and kinks.
4.3.
When connecting the regulator assembly to the valve, use your hand to tighten the nut
clockwise until it stops. Use of a wrench could damage the quick coupling nut and result in a
hazardous situation.
4.4.
Open the cylinder valve fully by turning the valve counter-clockwise.
4.5.
Before lighting the oven, use a soap and water solution to check all connections for
leaks.
4.6.
If a leak is found, turn the cylinder valve OF, and do not use the oven until a local liquid
propane dealer can make repairs.
DISCONNECTING THE LPG CYLINDER
1. Turn the burner valve OFF and make sure the pizza oven is cool.
2. Turn the liquid propane cylinder valve OFF by turning clockwise until it stops.
3. Detach the regulator assembly from the cylinder valve by turning the quick coupling nut
counter-clockwise.
4. Place the dust cap on cylinder valve outlet whenever the cylinder is not in use.
PATIO GAS REGULATOR
This is a push-on gas fitting. Ensure that the
black switch is in the horizontal
position.
Depress the button located below the black
switch and press the regulator on to the tank
valve until it locks into place.
POL GAS REGULATOR
This gas fitting is counter-clockwise. Make sure
that the tank is completely switched off and
screw the regulator as far as possible into the
gas tank valve.
