Kegel IKON Lane Machine, Руководство по эксплуатации

Страница: 63 / 167

50
Buffer Belt
Adjustment of the Buffer Belt is done with
the buffer brush in the
down position!
Loosen up the idler pulley and push it all the
way down and fasten tight.
Transfer Brush
The following steps adjust the transfer brush to the buffer brush.
1. Loosen the four ¼” jam nuts on each square head bolts and back them away
so that the transfer brush can move all the way in and out of the buffer brush
assembly.
2. Loosen the five ¼-20 bolts on the front side that secure the adjustment bar, but
keep them snug.
3. Using a ¼” wrench, screw the square headed bolts into the transfer brush to
lower. Do this until the Transfer brush just contacts the buffer brush assembly.
Once this happens, turn the screws two full turns and tighten them all the way.
Transfer Roller
1. With the machine in the operating position, loosen the roller pivot screws.
2. Then loosen the jam nut on the Roller adjusting screw and turn the screw in or
out until the 1/8” – 3/16” crush is obtained. By turning the adjustment screws
OUT, INCREASES THE CRUSH, by turning the screws IN, DECREASES THE CRUSH.
3. Tighten the jam nut and the pivot screws back
into place.
Adjusting screw
Pivot screws
Idler Pulley