SteelTrak 165 and 210 Installation
Manual
The world’s finest cutting machines
www.keencut.com
+44 (0) 1536 263158
+1 (716) 748 6203
[email protected] (UK HQ)
[email protected] (US sales)
Scan the QR code or
click here to view this document online >
Page 24 of 29
4. Calibration
4.1 Calibrating the vertical scale
The vertical measuring scale measures the height of the board on the machine and is only used for reference. It is supplied
separate from the machine, the two horizontal squaring arm scales are already attached to the machine but may not be
positioned accurately and will need calibrating.
Take a small piece of board and accurately measure its’ height,
place the board in the machine such that it lays over the groove
where the scale is to be applied.
With a pencil, mark a fine line level with the top edge of the
board adjacent to the groove.
Remove the release paper from the groove in the Main Body and
stick the Vertical scale in place such that the pencil mark lines up
with the measured dimension in (1).
