SteelTrak 165 and 210 Installation
Manual
The world’s finest cutting machines
www.keencut.com
+44 (0) 1536 263158
+1 (716) 748 6203
[email protected] (UK HQ)
[email protected] (US sales)
Scan the QR code or
click here to view this document online >
Page 18 of 29
2.7 Fitting the Free standing kit (210 only)
NOTE: The Free standing kit is an optional extra and does not come packed with the main machine. Assistance will be
needed to fit the Free Standing Kit
Extend the telescopic leg to the same length as the front legs less
12cm (5
″
)
Get help to hold the machine vertical and attach the bracket to
the top of the machine using the nuts and screws provided.
Be careful when lifting
Swing down the stay and attach the fixing block to the plate on
the bottom of the Main Body, tighten all three screws on the stay
using a 6mm Allen (Hex).
Adjust the telescopic leg so the machine stands evenly as shown.
Secure the top of the Legs to the Main Body by fitting the two M8
screws (supplied separately) through the black plate into the back
of each of the Legs, tighten these together with the adjacent two
screws (four screws in all) to fix the Legs in position with a 6mm
Allen (Hex) Key.
Attach the bracket to the end of the Squaring Arm as shown using
the two bolts provided.
Adjust the telescopic leg so the machine stands evenly as shown.
