KEDDY Christineberg, Руководство по установке

Страница: 14 / 20

- 12 -
27.
Screw a nut on top of the wing nut on the three front stud bolts that keep the cover down and add washers. Adjust
the nuts so the top edge of each washer is at the same height as the course of tiles. Then thread on the three plate
brackets and adjust them so that they cover approximately half the tile thickness. Lock each plate bracket with a locking
washer and nut. The brackets are thus fitted into the tile joint when the next course is assembled, thereby contributing
to greater stability.
28. Assemble tile course 7 in adhesive. Pay attention
to the hole for the cleaning hatch in tile 2.
REAR CONNECTION TO THE CHIMNEY
26. Connect the chimney connection sleeve to the
chimney, either at the rear to an existing chimney or,
alternatively, to a new chimney (element chimney).
Read the chimney's installation instructions if a new
chimney has been installed.
When connecting to an existing chimney, it is important
that the flue connection does not reach farther into the
chimney than the beginning of the flue. Make sure that the
insulation provides a good seal between the connection
sleeve and the hole in the chimney.
If there is no cleaning hatch in the existing chimney, a
bottom must be cast in the flue at the same height as
the bottom of the chimney connection sleeve. Fill up with
sand and finish with about 5 cm of plaster.
NOTE! The flue connection must not be bricked in
place!
1920 mm
Red
silicone
A B
Tile course 7
Tile course 7
NB! Hole for the cleaning hatch!
NB! Hole for the cleaning hatch!
Chimney
Chimney connection
sleeve
Insulation
Cleaning
hatch