Keba KeDrive D3-DA BG3, Руководство по эксплуатации

Страница: 59 / 84

59
1 Commissioning
Operation Manual KeDrive D3-DA BG3 and BG4
1804.200B.1-01 Date: 03/2023
Commissioning
Settings for the individual axes as follows:
KeStudio DriveManager Function
Set clock frequency for the power stage.
Motor configuration:
1. Load data set or
start identification / calculation
2. Set motor protection
3. Configure motor brake parameters
4. Undertake motor phase test
Encoder configuration:
1. Load data set or
set manually
2. Select encoder
3. Select encoder channel
Save settings in the device
NOTE:
If servomotors of type LSN, LSP or LST are used, the necessary motor and
encoder data sets can be loaded directly from KeStudio DriveManager.
The data sets for the motor range DMS2 are saved in the encoders and are
loaded directly from there.
NOTE:
You will find a detailed description of KeStudio DriveManager and its configu-
ration in the KeStudio DriveManager help.
5.3.2 Controlling drive using KeStudio DriveManager
For this part of the commissioning it is necessary to switch on the AC mains supply
(KeDrive D3-DP supply unit power supply). Check whether the power stage is enabled.
The drive should be tested without the coupled mechanism.
KeStudio DriveManager Function
Overview of all axes and their status
Device status
Check the error history
Status indication for axis 1
Status message for axis 1
Error message for axis 2
Status of the power stage
Status of the brake