P30
Introduction
Modbus TCP Programmers Guide V1.02
6
© KEBA
1.4
Requirements
The following requirements have to be met in order to use the Modbus TCP
functionality:
●
KeContact
P30
c-series
with firmware version
3.10.16
or higher,
or
KeContact
P30
x-series
with software version
1.11
or higher
●
A PC or smartphone for writing/reading registers via the Modbus TCP in-
terface.
This also requires a suitable client software or app.
●
The charging station has to be connected (via LAN cable) to the same
network as the application.
●
The Modbus TCP interface must not be used together with the UDP in-
terface and vice versa.
Information
The latest manuals, firmware and software can be downloaded here:
www.keba.com/emobility-downloads
1.5
Legal disclaimer
Specifications are subject to change due to further technical developments.
Details presented may be subject to correction.
This program guide applies exclusively to KeContact P30 c-series and to Ke-
Contact P30 x-series.
It is possible that the present program guide still has printing defects or print-
ing errors. However, the information in this program guide will be checked
regularly and corrections will be made in the next edition.
Liability claims against KEBA relating to material or immaterial damage
caused by the use or non-use of the information contained in the program
guide or by the use of incorrect or incomplete information are excluded.
KEBA shall only be liable for intent and gross negligence as well as for injury
to life, body or health as well as for violation of essential contractual obliga-
tions.
KEBA expressly reserves the right to change, supplement, adapt or delete
parts of the program guide without prior notice or to discontinue the entire
program guide temporarily or permanently.
Each integrator is responsible for updating and maintaining the applicable
system. There are no legal claims and/or liability claims for failure of systems
due to non-updated Modbus TCP commands.
