Keba D3DP 3 Series, Руководство по проектированию устройства, Страница: 15 / 82

D3­DP 3xx/x Safety notes
Project engineering manual V1.00
15
© KEBA
2.2 General safety instructions
DANGER!
Safety and operating instructions for drive converters (acc. to: Low
voltage directive 2006/95/EC).
● During operation, drive power converters can, in accordance with their
degree of protection, have life, bare, possibly even moving or rotating
parts, as well as hot surfaces.
● Inadvertently removing the necessary covering, inappropriate use, incor­
rect installation or operation causes the risk of severe personal injuries,
material damage or even fatal injuries.
● Further information can be found in the product documentation. Com­
missioning is not permitted if the product documentation is missing. In
this case you should immediately ask for a new product documentation.
● Commissioning is only permitted if you understand the language of the
product documentation. Otherwise commissioning must be performed by
a specialist who understands the language.
● All work concerning transportation, installation and commissioning as
well as repair and maintenance must only be carried out by qualified ex­
pert personnel.
WARNING!
● It is absolutely essential that you also observe the safety instructions in
the system manual and the safety manual "Functional safety" for your
automation system.
● The following areas of application are expressly excluded for the D3­DP
3xx/x:
● Use in areas where there is a risk of explosion or fire
● Use in the mining sector
● Use in outdoor areas
● Use in wet rooms or rooms with the risk of splashing water
● Use in environments with heavily polluted air
● Use in environments with harmful solutions, steams or radiations
● Use in non­stationary applications
● Direct use on a DC motor
● Other products are to be used for these applications!
● The module is defined as "open type equipment" (UL 508) or as "open
equipment" (EN 61131­2) and must therefore be installed in a control
cabinet.