KEB COMBIVERT F5, Руководство по установке

Страница: 9 / 28

GB - 9
Control
2.2.1 LED1
The COMBIVERT F5 can be ordered without operator for applications when locally operation
is not required. A status LED for the display of the inverter status is used for the variant wit -
hout operator.
LED status Function
off Unit switched off
on Unit ready for operation
flashing Unit in malfunction
2.2.2 HSP5 interface X4A
The HSP5 interface X4A serves for the communication with a control operator. A digital ope -
rator, interface operator and different fieldbus operators are available for this. In order to
avoid malfunctions, the inverter must be brought into noP status before plug on / plug off the
operator (open control release). At start-up the inverter is always started with the last stored
values or factory setting.
A special HSP5 cable (part number 00.F5.0C0-0010) is required for the operation of the KEB
COMBIVERT without operator. This cable is connected between HSP5 interface X4A and
serial RS232 PC interface (COM1 or COM2). The operation occurs via COMBIVIS.
The HSP5 service cable has an integrated level converter. The connection of a serial
standard cable would destroy the PC interface.
2.2.3 Encoder interfaces X3A, X3B
The COMBIVERT F5 can be equipped optionally with encoder interfaces. Different combi -
nations can be used here according to the requirements. The instruction is made separately
according to the installed encoder interfaces.
2.2.4 Operators
The COMBIVERT F5 can be equipped optionally with operator. Different control or field bus
operators are available here according to the requirements. The instruction is made separa -
tely according to the installed operator.
2.2.5 Control terminal strip X2A
The control terminal block X2A is designed as double, plug-in terminal block with spring cage
connection. It contains 32 pole.
2.2.6 Safety terminal block X2B
The safety terminal block X2A is designed as double, plug-in terminal block with spring cage
connection. It contains 10 pole.